SDS

Ultimate Quik Detailer G2010 [G201016]
03/03/20
Page 3 of
8
6.1. Personal precautions, protective equipment and emergency procedures
Ventilate the area with fresh air. Observe precautions from other sections.
6.2. Environmental precautions
Avoid release to the environment. For larger spills, cover drains and build dikes to prevent entry into sewer systems or
bodies of water.
6.3. Methods and material for containment and cleaning up
Contain spill. Remember, adding an absorbent material does not remove a physical, health, or environmental hazard.
Collect as much of the spilled material as possible. Place in a closed container approved for transportation by appropriate
authorities. Clean up residue with water. Seal the container. Dispose of collected material as soon as possible in
accordance with applicable local/regional/national/international regulations.
SECTION 7: Handling and storage
7.1. Precautions for safe handling
Keep out of reach of children. Avoid release to the environment. Avoid contact with oxidizing agents (eg. chlorine,
chromic acid etc.)
7.2. Conditions for safe storage including any incompatibilities
Store away from heat. Store away from acids. Store away from oxidizing agents.
SECTION 8: Exposure controls/personal protection
8.1. Control parameters
Occupational exposure limits
No occupational exposure limit values exist for any of the components listed in Section 3 of this SDS.
8.2. Exposure controls
8.2.1. Engineering controls
No engineering controls required.
8.2.2. Personal protective equipment (PPE)
Eye/face protection
Select and use eye/face protection to prevent contact based on the results of an exposure assessment. The following eye/face
protection(s) are recommended:
Safety Glasses with side shields
Skin/hand protection
No chemical protective gloves are required.
Respiratory protection
None required.
SECTION 9: Physical and chemical properties
9.1. Information on basic physical and chemical properties