SDS

G1903, Ultimate Tire Shine (31-19B): G190315
07/17/18
Page 4 of
10
Ingredient
C.A.S. No.
Agency
Limit type
Additional Comments
Acetone
67-64-1
ACGIH
TWA:250 ppm;STEL:500 ppm
A4: Not class. as human
carcin
Acetone
67-64-1
OSHA
TWA:2400 mg/m3(1000 ppm)
METHYL ACETATE
79-20-9
ACGIH
TWA:200 ppm;STEL:250 ppm
METHYL ACETATE
79-20-9
OSHA
TWA:610 mg/m3(200 ppm)
authorized person. Ventilate the area with fresh air. Read and follow safety precautions on the solvent label and SDS. Seal
the container. Dispose of collected material as soon as possible in accordance with applicable
local/regional/national/international regulations.
SECTION 7: Handling and storage
7.1. Precautions for safe handling
Keep out of reach of children. Keep away from heat/sparks/open flames/hot surfaces. - No smoking. Do not spray on an
open flame or other ignition source. Do not pierce or burn, even after use. Avoid breathing
dust/fume/gas/mist/vapors/spray. Do not get in eyes, on skin, or on clothing. Do not eat, drink or smoke when using this
product. Wash thoroughly after handling. Avoid contact with oxidizing agents (eg. chlorine, chromic acid etc.)
7.2. Conditions for safe storage including any incompatibilities
Store in a well-ventilated place. Keep container tightly closed. Protect from sunlight. Do not expose to temperatures
exceeding 50C/122F. Store away from acids. Store away from oxidizing agents.
SECTION 8: Exposure controls/personal protection
8.1. Control parameters
Occupational exposure limits
If a component is disclosed in section 3 but does not appear in the table below, an occupational exposure limit is not available
for the component.
ACGIH : American Conference of Governmental Industrial Hygienists
AIHA : American Industrial Hygiene Association
CMRG : Chemical Manufacturer's Recommended Guidelines
OSHA : United States Department of Labor - Occupational Safety and Health Administration
TWA: Time-Weighted-Average
STEL: Short Term Exposure Limit
CEIL: Ceiling
8.2. Exposure controls
8.2.1. Engineering controls
Use general dilution ventilation and/or local exhaust ventilation to control airborne exposures to below relevant Exposure
Limits and/or control dust/fume/gas/mist/vapors/spray. If ventilation is not adequate, use respiratory protection equipment.
8.2.2. Personal protective equipment (PPE)
Eye/face protection
Select and use eye/face protection to prevent contact based on the results of an exposure assessment. The following eye/face
protection(s) are recommended:
Indirect Vented Goggles
Skin/hand protection
Select and use gloves and/or protective clothing approved to relevant local standards to prevent skin contact based on the
results of an exposure assessment. Selection should be based on use factors such as exposure levels, concentration of the
substance or mixture, frequency and duration, physical challenges such as temperature extremes, and other use conditions.
Consult with your glove and/or protective clothing manufacturer for selection of appropriate compatible gloves/protective