Manual

5.2 Making a CONTINUITY measurement
1. Set the Primary (Left) range knob to
W
range. (The position of the right hand rotary range knob must not be in
the position).
2. Connect two test leads to the L1 (+ve) and L2 (-ve) terminals on the instrument.
A continuity measurement is made automatically.
L
N
E
g
NOTE : Measurements are prevented when:
 A resistance of > 99.9 kΩ is present
 Circuit voltages in excess of 4 V are detected.
5.3 Storing / downloading results (Not MFT1815 or MFT1825)
For full details see “13. Appendix A – Sending, Storing, Deleting and Recalling Test Results (MFT1835 and
MFT1845+)” on page 56
Once the display shows a value it will automatically be logged into temporary memory. Unless stored, this will be over
written by the next measurement.
To store this result or to send it to Certification Software (such as CertSuite.app), refer to “13. Appendix A –
Sending, Storing, Deleting and Recalling Test Results (MFT1835 and MFT1845+)” on page 56.
5.4 Continuity Buzzer ON/OFF
Whilst in the continuity range, press the MODE button . This will toggle the buzzer ON and OFF.

Buzzer ON = Buzzer OFF = No symbol
www.megger.com
MFT1800 series
22
Continuity / resistance measurement