Manual

The following charging capabilities can be simulated: N/C (No Connection), 13 A, 20 A, 32 A and
63 A, as well as all the possible electrical vehicle modes A, B, C (un-vented) and D (vented), via the
selection switches.
Also provided are 4 mm connection ports L1, L2, L3, N, PE and CP signal terminals to which
appropriate measuring equipment can be connected for further testing. Charging points should be
tested as part of the initial installation and checked periodically.
The Megger EVCA210 has available two connection cables with the following plug options:
Type 2 connector plug - for charging points with panel mounted socket outlet or fixed cable with
Type 2 vehicle socket connector
Type 1 connector plug* - for charging points with fixed cable and Type 1 vehicle socket connector
(Example Mitsubishi PHEV).
*Note: The Type 2 to Type 1 adaptor is supplied as standard with the EVCA210-UK only.
5. Connecting the EVCA210 test adaptor to the charging Point
1. Connect the Type 2 to Type 1 adaptor if required.
2. Connect EVCA210 to the charging point to be tested using chosen charging plug cable.
Fig 1: EVCA210 adaptor connection to the charging point.
www.megger.com EVCA210
9
Connecting the EVCA210 test adaptor to the charging Point