Datasheet

EVCA210 EVCA210-UK
Input voltage 250 V (single phase system) / 430 V
(three phase system),
 
Push Button for PE Pre-Test
 
Rotary switch providing PP State simulation
 
Rotary Switch providing CP State simulation
 
Push button for CP Error “E” simulation
 
Push button for PE Error (Earth Fault) simulation
 
Measurements on live conductors (L1, L2, L3 and N)
and on PE conductor
 
Mains Socket: EVCA210-UK - 13A UK socket
EVCA210 - Schuko socket (CEE 7/3)
 
CP signal test, two 4 mm ports for connection to an
oscilloscope
 
CAT II 300 V
 
Fixed Type 2 Plug for charging points with panel
mounted socket outlet or fixed cable with vehicle
connector.
 
Type 1 to Type 2 adaptor for charging points with
fixed cable and vehicle connector – Supplied with
EVCA210-UK as standard

Soft Carry Case
 
EVCA210/EVCA210-UK
Electric vehicle charge-point adaptor
IEC 60364-7-722:2018 Low-voltage electrical installations
- Part 7-722: Requirements for special installations
or locations - Supplies for electric vehicles and any
documentation relating to the charging station itself.
All Megger EVCA210 variants are supplied with a fixed Type
2 connector plug. The EVCA210-UK is also supplied with
a Type 2 to Type 1 adaptor plug as standard - optional for
other variants.