Manual

MEGATRON
®
LED Solar Wall Luminaire – LOKY RUND
TECHNICAL SPECIFICATION
Instruction manual
GB
Series Name
MEGATRON
®
LOKY RUND
Model Number MT70017
Color Graphite
Wattage 1W
Luminous Flux 110lm
Color temperature Warmwhite (3000K)
Solar cell 0,7Wp
Charging time approx.15 h
Operating time up to 22 h (100%)
Battery type Lithium-Ion18650
Capacity 2200mAh
Volt DC 3,7V
Battery replaceable Yes
IP rating
IP54
MOUNTING INSTRUCTIONS:
Install the luminaire only where it gets enough sunlight. The charging time depends on the sunlight exposure.
Avoid close proximity to other light sources. Make sure that the solar luminaire is installed at a distance of at least one meter to avoid light interference.
Make sure the luminaire is located in a shadow-free area where sunlight is not obstructed by objects.
Suitable for outdoor use.
The lithium-ion battery is pre-charged.
The lithium-ion battery is also charged when the light is NOT ACTIVATED (see ”First-time use”).
The operating temperature of the luminaire is -20°C to +45°C.
The battery is approved up to +45°C. Avoid higher temperatures under all circumstances.
ATTENTION:
Remove battery
1. Loosen screws
2. Remove housing cover
3. Remove the battery from the holder
CAUTIONS:
Read the entire manual carefully before installation and operation.
DO NOT disassemble the inner part of the luminaire. Doing so many result in luminaire damage or malfunction.
The light sources of this luminaire are not replaceable; when the light source reaches its end of life, replace the entire luminaire.
The manufacturer accepts no liability for any damage resulting from the misuse of the luminaire or from when is it used with inappropriate equipment.
Please do not place any objects on the solar panel, the battery is located underneath. There is a risk of fire!
Consult your dealer if you have any enquiries.
Please observe the maximum operating
temperature +45°C. Do not place on
metallic objects!
-20
°
C
+45
°
C
Contains Lithium-Ion battery!
1. 2. 3. 4.
Mount the luminaire's bracket at a height
of minimum 1,5m maximum 2m to allow
the luminaires's PIR sensor to reach its full
detection range.
Sealing rings
Washer
Part List:
1 x Solar luminaire
with
integrated PIR sensor
1 x wall mount
4 x Dowels
4 x Screws
4 x Washer
4 x Sealing rings

Summary of content (2 pages)