Specifications

Second Installation procedure
The second part of the Installation procedure requires another submit to be executed. The
submit to be executed is dependent on the mode chosen for the video output. If the alpha-
numeric
mode is to be used then QASETUP.SUB is used. If the graphics mode is to be used
QGSETUP.SUB is executed. To continue with the procedure enter one of the following:
A>SlB QASE1\P
if the alphanumeric mode terminal driver is being installed,
-or-
A>St13 QGSETlF
if the graphics mode terminal driver is being installed.
The second part of the installation procedure wi II assemble and l ink all pertinent fi lese
At the completion of this section the new system will be written to a file called QCPM.SYS.
Final steps in the Installation procedure
______________________ 0 _____________________________ , __________________________ __
At this point a temporary CP/M system wi II be required to transfer the system and data
from the distribution disk to the target system drive. The following system is required:
-Drive 'A' format should
be the same as the Distribution disk format
-Drive 'B' format should
be the same as the user's target system drive 'A'
This
way the user can access his own format through drive B whi le operating under this
temporary system. Additionally, he can read and write to the Distribution Diskettes through
drive
A.
To create the temporary system as described above the DFCU utility is used.
Follow the example below:
A>DFCU QSYS.DAT
DISK FORMAT CONFIGURATION UTILITY VERSION 2.23
DFCU prompts user for the specifications of
disk drives
and disk formats, and lets the user
configure the disk drive parameter tables
in
memory directly, all without the need to
reassemble or regenerate the O/S. However
the configuration is only temporary until
the next system reset.
MAIN MENU SELECTION
A. DISK DRIVE SPECIFICATIONS AND OPERATIONS
B. LOGICAL DISK FORMATS AND OPERATIONS
X. RETURN TO O/S
ENTER -B
Megatel Computer Technologies . Toronto, Canada
Page S/W-21