User`s manual

5
2.1 Setting Up
1. Slide the battery door open & plug the battery connector to the
Pico projector, as indicated by the following sequence of photos.
The battery compartment was designed to accommodate different
batteries, and as sizes can vary, double sided adhesive tape
on the batteries can be used to hold it in place.
2. Insert the battery to the battery compartment.
3. The battery needs to be charged 6-8 hours the first time it is
used. Plug the Power Adaptor to the DLP Pico Projector.
4. Slide the On/Off side button, hold it for one second then release
it to start the DLP Pico Projector. The Projector will take about
On/Off Power Button
Vo
lume Button
Source Button
Micro SD Card connector