User's Manual

39-T1 User Manual Rev. 4.0 Updated on 20DEC2016
Technical Contacts and Enquiry: [e-mail] Website: www.myndar.com
(This user manual / product specification is subjected to be changed without prior notice) P.23
Federal Communications Commission (FCC) Compliance
These products operate at the following frequencies in compliance with Part 15 of the
FCC rules:
 RFID; 902 MHz - 928 MHz,
Operation is subject to the following two conditions: 1) this device may not cause harmful
interference, and 2) this device must accept any interference received, including
interference that may cause undesired operation.
To comply with the FCC radio frequency exposure requirements, the following antenna
installation and device operating configurations must be satisfied:
• Product models using external antennas require professional installation. The antennas
used for professional installation must be fixed-mounted on indoor/outdoor permanent
structures with a separation distance from all persons of at least 25 cm (approximately 8
inches).
• Antennas must not be co-located and must not operate in conjunction with any other
antenna or transmitter.
• Shielded cables must be used with this unit to ensure compliance with the Class B FCC
limits.
Warnings
Changes or modifications to this unit not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
The equipment has been tested and found to comply with part 15 of the FCC rules.
These limits are designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try and correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet or on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio / technician for help.
To ensure safety of users, the FCC has established criteria for the amount of radio
frequency energy that can be safely absorbed by a user or bystander according to the
intended usage of the product. This product has been tested and found to comply with the