Setup guide

Mega 200VWR Router

Chapter 3: Basic Installation

Information from your ISP

Telkom ADSL connections use PPPoE, and automatically assign a WAN IP address to your router; The

following information is provided should you wish to connect to an alternative ISP. .

Gather the information as illustrated in the following table and keep it for reference.

PPPoE

VPI/VCI, VC / LLC-based multiplexing, Username, Password, Service Name,

and Domain Name System (DNS) IP address (this is automatically set by the

Telkom network but be set manually should this be required).

PPPoE / PPPoE

with Pass-through

VPI/VCI, VC / LLC-based multiplexing, Username, Password, Service Name,

and Domain Name System (DNS) IP address (this is automatically set by the

Telkom network but be set manually should this be required). In addition,

additional WAN address can be assigned using PPPoE dialer.

PPPoA

VPI/VCI, VC / LLC-based multiplexing, Username, Password and Domain

Name System (DNS) IP address (it ca be automatically assigned by your ISP

when you connect or be set manually).

RFC 1483 Bridged VPI/VCI, VC / LLC-based multiplexing to use Bridged Mode.

RFC 1483 Routed

VPI/VCI, VC / LLC-based multiplexing, IP address, Subnet mask, Gateway

address, and Domain Name System (DNS) IP address (it is a fixed IP

address).

IPoA Routed

(IP over ATM)

VPI/VCI, VC / LLC-based multiplexing, IP address, Subnet mask, Gateway

address, and Domain Name System (DNS) IP address (it is a fixed IP

address).