Setup guide

Mega 200VWR Router

Appendix A: Product Support and Contact Information

159

c) Your router will now attempt to synchronize with the Telkom ADSL line. The

“ADSL/PPP” LED will start to blink green and after approximately 1-2 minutes

be steadily lit orange. If the “ADSL/PPP” LED does not become lit, please refer

to the troubleshooting section at the end of this guide.

d) The Mega 200VWR router is, by default, distributed with a guest ISP

username and password. This guest account allows you access to the

www.telkom.co.za website only. Although this account only allows limited

access, it serves as a tool to confirm that your hardware installation and your

own PC’s network configuration has been completed successfully. This guest

account will cause your router’s “ADSL/PPP” LED to be steadily lit orange now.

We will again refer to this guest account at a later stage of the installation

process.

3. Connect the LAN (network) cable

a) Plug one end of the enclosed (yellow) Ethernet (CAT-5 LAN) cable into one of

the router’s LAN ports, you may choose any of the 4 ports (E).

b) Plug the other end of the Ethernet (CAT-5 LAN) cable into your computer’s

network port or network hub/switch (F).