Setup guide

Mega 200VWR Router

Appendix A: Product Support and Contact Information

158

APPENDIX A: Windows 98 setup

Installation & Setup: (Windows 98, 98SE, ME or NT4)

Hardware Installation:

Follow the installation instructions below, referring to the images provided for each step. Also

note the hardware overview diagram (Figure 1) and the corresponding letter indicators.

1. Power up the device

a) Plug the power adapter into the electrical wall-socket (A).

b) Plug the power pin-connector (male) into the router’s power socket (B).

c) Switch the router on.

d) Wait approximately 1 minute, then confirm that the “PWR” and “SYS” LED’s

(front panel lights) are steadily lit.

2. Connect the ADSL line

a) Connect one of the included (grey) telephone cable between the Telkom

wall-socket and one of the sockets on the integrated power and surge unit (C).

b) Connect the other included (grey) telephone cable between the remaining

unused socket on the integrated power and surge unit and the router’s “ADSL”

port (D).