Specifications

Mega 100WR2 ADSL2+ Router - Manual
Page 60 of 81
• Busybox Utility: 0xEF
• Configuration Manager: 0xF0
• DropBear Utility: 0xF1
• Voice: 0
Currently, routing algorithms make decisions based on destination address, i.e. only Destination
IP address and subnet mask is used. The Policy Routing page enables you to route packets on
the basis of various fields in the packet. The following fields can be configured for Policy
Routing:
Destination IP address/mask
Source IP address/mask
Source MAC address
Protocol (TCP, UDP, ICMP, etc)
Source port
Destination port
Incoming interface
DSCP
4.5.28 Static Routing
If the Mega 100WR2 router is connected to more than one network, you may need to set
up a static route between them. A static route is a pre-defined pathway that network
information must travel to reach a specific host or network. You can use static routing to
allow different IP domain users to access the Internet through the Mega 100WR2.