Specifications

Mega 100WR2 ADSL2+ Router - Manual
Page 35 of 81
To create a temporary user account for a remote access to your router, follow the procedure
below.
1. Select WAN Update to enable write privileges on the router for the remote user.
2. Select WAN Access to enable read privileges on the router for the remote user.
3. Enter a user name and password in the User Name and Password fields.
4. Enter a port number In the Port field (for example, 51003).
5. Click Apply to temporarily activate the settings on the page.
Note—the changes take effect when you click Apply; however, if the router configuration is not
saved, these changes will be lost upon reboot.
6. To make the change permanent, click Save Settings.
7. To access your router remotely, enter the following URL in a browser :
http(s)://WAN IP of router:Port Number
4.5.13 TR-069
TR-069 is a CPE (Customer Premises Equipment) Management Protocol to be used on WAN
interfaces, and is intended for communication between a CPE router and an Auto-Configuration
Server (ACS). TR-069 enables the secure auto-configuration of a CPE, and also incorporates
other CPE management functions into a common framework.
The CPE WAN Management Protocol is intended to support a variety of functionalities to
manage a collection of CPE, including the following primary capabilities:
Auto-configuration and dynamic service provisioning
Software/firmware image management
Status and performance monitoring
Diagnostics
Figure 4-27Error! Reference source not found. shows the default TR-069 page, which is
accessed by clicking the TR-069 link on the Advanced page. The TR-069 page allows you to set
up connection parameters.