Specifications

Mega 100WR2 ADSL2+ Router - Manual
Page 25 of 81
4.5 Advanced
This mode is catered for advance users, a brief explanation of the links are listed as shown
below. See Figure 4-15.
Figure 4-15: Advanced Screen
4.5.1 WAN Connection
The Wide Area Network (WAN) connection exists on the “other” side of the Router, also
referred to as a broadband connection. This WAN connection configuration is different
for each ISP. Your Mega 100WR2 is set by default to connect to the Telkom ISP and
should work as it is (once you have entered username and password information). Should
you wish to use this router to connect to any other ISP, you may need to change the
relevant configuration data.
4.5.2 New Connection
A new connection is a virtual connection. Under normal conditions, you will require only
one virtual connection. Your Mega 100WR2 Router, can however, support up to 8
different (unique) virtual connections. If you have multiple different virtual connections,
you may need to utilize the static and dynamic routing capabilities of the modem to pass
data correctly. Your Router is supplied with its first connection (quickstart) pre-
configured (described below) .You may add up to 7 more, and may change the quickstart
connection if required.