Operator`s manual

depending on the brightness of the
ambient light.
With the engine running, the low‑beam
headlamps, the tail and parking lamps,
the license plate lamps and the side
marker lamps will come on and go out
automatically depending on the
brightness of the ambient light.
Daytime running lamp mode (Canada only)
X
Turn the exterior lamp switch to position
$.
i
With the daytime running lamp mode
activated and the engine running, the
low‑beam headlamps cannot be switched
off manually.
You cannot switch on the high‑beam
headlamps.
The high‑beam flasher is available at all
times.
For nighttime driving you should turn the
exterior lamp switch to position L to
permit activation of the high‑beam
headlamps.
When the engine is running, and you
R
turn the exterior lamp switch to position
T, the low‑beam headlamps, the tail
and parking lamps, the license plate
lamps and the side marker lamps come on.
R
turn the exterior lamp switch to position
L, the manual headlamp mode has
priority over the daytime running lamp
mode. The corresponding exterior lamps
come on.
Combination switch (high beam, high-
beam flasher and turn signals)
X
Make sure the key is in starter switch
position 1.
High‑beam headlamps
X
Make sure the low‑beam headlamps are
switched on (Y page 67).
X
Switching on: Push the combination
switch to position 1.
The high‑beam headlamps come on.
The high‑beam headlamp indicator lamp
K in the instrument cluster comes on.
X
Switching off: Pull the combination
switch to position g.
The high‑beam headlamps go out.
The high‑beam headlamp indicator lamp
K in the instrument cluster goes out.
High‑beam flasher
X
Pull the combination switch briefly in
the direction of arrow ;.
Turn signals
:
Turn signals, right
;
Turn signals, left
68
Lighting
>> Controls.