Operator`s manual

cooling system, or if the coolant
temperature warning lamp ? in the
instrument cluster indicates that the
coolant is overheated.
R
Do not remove pressure cap on coolant
reservoir if coolant temperature is
above 158¦ (70¥). Allow engine to cool
down before removing cap. The coolant
reservoir contains hot fluid and is under
pressure.
R
Using a rag, slowly open the cap
approximately
1
/
2
turn to relieve excess
pressure. If opened immediately,
scalding hot fluid and steam will be
blown out under pressure.
The engine coolant is a mixture of water
and anticorrosion/antifreeze. To check the
coolant level the vehicle must be parked on
level ground and the engine must have
cooled down. For more information, see
“Coolants” (Y page 213).
Checking coolant level
X
Remove the service flap and insert it on
the front of the vehicle (Y page 114).
The coolant reservoir is located in the
front compartment on the driver’s side.
X
Allow the radiator to cool down for at
least 30 minutes.
X
Using a rag, turn pressure cap : slowly
approximately one half turn
counterclockwise to release any excess
pressure.
X
Continue turning pressure cap :
counterclockwise and remove it.
The coolant level is correct if the level
R
for cold coolant: reaches marking
bar ; visible through the filling
opening
R
for warm coolant: is approximately
0.6 in (1.5 cm) higher
X
If necessary, add coolant.
Adding coolant
X
Add coolant as required. The coolant
level may not exceed the maximum filling
level.
X
Replace and tighten pressure cap :.
X
Remount the service flap and close it
(Y page 114).
Windshield/rear window washer system
Both the windshield and the rear window
14
washer are supplied from the windshield
washer reservoir.
The recommended minimum filling level is
1.06 US qt (1.0 l).
X
Remove the service flap and insert it on
the front of the vehicle (Y page 114).
14
Coupé only.
116
Front compartment
>> Operation.