Specifications

For use by licensed certifier:
Name: Vehicle Id:
Signature: Date of Assessment:
Brake assessment manual Ver 1.0 Published October 2013 18 (48 pages)
Appendix 3: Brake system installation checklist
This checklist should be used by the vehicle modified and presented to the licensed certifier for
the purposes of the initial assessment.
Vehicle owner: ……………………………………………….
Vehicle modifier: ……………………………………………….
Vehicle make and model: ……………………………………………….
Date of inspection: ……………………………………………….
Vehicle identification: ……………………………………………….
Licensed certifier: ……………………………………………….
Date of assessment: ……………………………………………….
BRAKING SYSTEM INSTALLATION CHECKLIST
1 SERVICE BRAKING SYSTEM
(a) With the service brakes applied, are there any fluid leaks from the
braking system?
Y N N/A
(b) Does the service brake system operate on all wheels?
Y N N/A
(c) Are all components of the service brake system in a safe and
serviceable condition?
Y N N/A
(d) If a single-circuit service brake system is replaced with dual
circuit system is the pressure variation between each circuit
balanced and/or adjusted automatically by the system?
Y N N/A
(e) Is the brake proportioning valve or load sensing valve connected
and in good working condition?
Y N N/A
(f) When the service brakes are applied, do the brakes on all wheels
apply simultaneously and without causing excessive “nose-dive”?
Y N N/A
(g) When the service brakes are released, do the brakes on the
relevant wheels release immediately and simultaneously?
Y N N/A
(h) Are all pumps, servos and accumulators connected and in good
working condition?
Y N N/A
(i) With the ignition switch in the “on” position and the engine nt
running, is each audible/visual warning device connected and
functional?
Y N N/A
2 SERVICE BRAKE CONTROL
(a) Is there sufficient clearance around the service brake control to
ensure that it can be operated without interference from the
vehicle’s interior or other driving control?
Y N N/A