User manual

MultiMonitor

1.0. Introduction

iMultiView is a program to manage multiple WebCAM. It is able to detect the IP

address of all WebCAM installed in LAN and list them for easy management. For

units that are located on WAN, the administrator will have to manually add these in.

1.1. Installing the program from CD

1. Insert the enclosed Utility CD into the CD-ROM drive. The following menu will

show up. Click on the buttons on the left to install the programs you want.

 iCAMView Utility - This is a program that helps the user perform quick

installation. It will detect the current configuration and take the user through

the necessary network setup.

a. Click the iCAMView Utility button to commence installation.

b. After the installation is completed, iCAMView Utility program will

appear in Windows, Start  All Programs  iCAMView 

iCAMView Utility. Click this to start the program.



iMultiView - This is a windows based program designed to allow user to

control a large number of WebCAM IP camera located either in a LAN or

WAN.

a. Click the iMultiView button to commence installation.