User manual

iCAMView Utility
Once set, Utility will request for the Device Password when you try to click on
either, Setup Wizard, Launch iCAMView or IP Configuration button.
To remove the password,
No Devise
Password
is set.
If the Devise
Password is
enabled, the
IP Address
will be
hidden.
a. Select the iCAMView unit from the Utility list.
b. Click IP Configuration.
c. Enter the unit’s Device Password
d. Go to Advanced Device Password and delete both the entries.
e. Click OK to confirm.
NOTE:
If the password is lost, you must use the Master Password to reset the Password
field
ii. Management Protocol
This setting allows the administrator to determine the LAN HTTP access (web)
to iCAMView IP camera. To limit access, the administrator can choose to use
either the default open port 80 or other ports (between 1 to 65534).
Once the HTTP port number is set to another port (other than 80), the full LAN
IP address must be entered in order to access the iCAMView web interface.
12