User manual

iCAMView Utility

Choose this if you want your Router to assign an IP address to iCAMView. This

is the default setting.

Obtain an IP address by Bootp

Choose this if you want to allow iCAMView to obtain an IP address using Bootp

protocol.

Use the following IP Address

Choose this if you want to assign a fix IP address, Subnet Mask and Gateway for

iCAMView.

1.2.3.2 Advanced (for password and HTTP configuration)

This section sets security password against unauthorised access to devices through

this Utility.

Fig.3 IP Configuration: Advanced settings

i. Device Password (when accessing from Utility)

Use this to set an access password to iCAMView Utility. Once set, the IP

Address will not be shown on the right display panel (see below).

Device Password can only be set for iCAMView from within the same LAN by

an Administrator.