User manual

Chapter 3: Web Interface
3.2.4.2 Image Settings
This page allows the Administrator to set various items related to video detection.
Only an Administrator can setup Motion Detection and Image Recording functions.
i. Motion Detection
Fig.34 Motion Detection page
Enable
The Administrator has three options for Motion Detection;
a. Always On, or;
b. On Schedule, the Administrator can set up to 4 different time slots for
motion detection, or;
c. No to turn Motion Detection function off.
Note:
Check that you have setup valid Email / FTP accounts first before proceeding with
the rest of the configuration.
To setup Email / FTP, refer to Section 3.2.4.3
Detection Sensitivity
This will determine the level of change before motion capture is triggered. A
high percentage means a small change will trigger motion capture.
Send image every … second(s)
Select either; 0.5, 1, 2, 3, 4 or 5 seconds.
Stop sending after … email(s) or image idle for … second(s)
iCAMView will stop sending emails on the lower of the two conditions. The
Administrator can set between 1, 3, 5, 7 and 10 seconds. Emails can be set
from 1 to 99999 pieces or 0 for stop sending email only when image idle
occurred.
Schedule
When the unit is set to On Schedule, the Administrator can configure the four
preferred schedule time slots for motion detection. Time must be entered in
24hr format.
iCAMView - user manual -34-