User manual

Chapter 3: Web Interface
Enter a
name for
the selected
hotspot
Patrol Setting
Enter a
name for
the selected
hots
p
ot
Boundary
This defines the camera patrol boundary. Click and hold on either one of the
two boundary bubble to redefine the boundary.
Auto Patrolling
Select Yes to start auto patrolling function.
Select No to stop the patrolling function.
Format
Choose from 5 different patrolling formats;
a. Oscillating – The camera will pan and tilt at the same time within the user
defined boundary. Camera will oscillate from left to right and back.
b. Square – The camera will patrol along the user defined boundary in a clock
wise manner.
c. Pan only – The camera will perform Pan function only.
d. Tilt only – The camera will perform tilt function only.
e. In sequence (1-5) – The camera will jump to each Hotspot location in
sequence and wait for 10 seconds in each spot.
Pan speed / Tilt Speed
Use this to define the Pan and Tilt speed. By default this is set to 10, the
fastest setting. The administrator can further customize by choosing different
Pan / Tilt speed.
3.2.3.3 NetFeeler Lite Settings (only if device is connected)
This additional option can be seen if a NetFeeler Lite is connected.
iCAMView - user manual -19-