User manual

Load Show from USB
1. Insert USB flash drive
2. Press and hold the Run Mode and the button at the same time until display reads Load.
3. Press the Fixture button 1-16 as the show you want to load.
Note: If green indicator light is on there is an existing file in the USB.
=Q-loader 1
=OK
When the Display reads OK the file is backed up to USB flash drive
Caution!
1. Do not remove USB flash
drive while operational
Load Show from Website-USB
Go to www.mega-lite.com/prolight/dmxcont/qloader
1. Select desired show to load to USB Flash Drive.
2. Insert USB flash drive
3. Press and hold the Run Mode and the button at the same time until display reads Load.
4. Press the Fixture 1 as the show you want to load.
=Q-loader 1
=OK
When the Display reads OK the file is backed up to USB flash drive
Caution!
1. Do not remove USB flash
drive while operational
Cleaning and maintenance
Installation Maintenance: The operator has to make sure that the unit is operating safely and has the installations and electron-
ics checked by an expert every 2 years.
The following points have to be considered during the inspection:
1) All screws used for installing the device or part of the device have to be tightly connected and must not be corroded.
2) There must not be any deformations on the housing, fixation and installation spots .
3) The electronic power supply cables must not show any damages, material fatigue (e.g. porous cables) or sediments. Further
instructions depending on the installation spot and usage have to be adhered by a skilled installer and any safety problems
have to be removed.
Note: There is no serviceable parts inside the device. Maintenance and service operations are to be carried out by authorized
dealers.
Replacing the Power supply: Only replace the power supply with the same type and rating.
Should you have further questions , please contact your dealer.
Parts List
MC2010-KB Fader Knob
MC2010-PS Power Supply
9