User manual

Cleaning and maintenance

Installation Maintenance: The operator has to make sure that the unit is operating safely and has the installa-

tions and electronics checked by an expert every 2 years.

The following points have to be considered during the inspection:

1) All screws used for installing the device or part of the device have to be tightly connected and must not be corroded.

2) There must not be any deformations on the housing, fixation and installation spots (ceiling, suspension, trussing).

3) Mechanically moved parts like axles and other must not show any traces of wearing and must not rotate with unbal-

ances.

4) The electronic power supply cables must not show any damages, material fatigue (e.g. porous cables) or sediments.

Further instructions depending on the installation spot and usage have to be adhered by a skilled installer and any

safety problems have to be removed.

Disconnect from mains before starting maintenance operation!

Caution Danger to life!

We recommend a frequent cleaning of the device. Please use a moist, lint free cloth. Never use alcohol or solvents!

1) The objective lens will require periodic cleaning on usage and environment. Environment with foggers will require

more periodic cleaning as fog fluid tends to build up residues, reducing the light output.

2) The cooling-fans should be cleaned monthly. DO NOT blow high pressure air into fans as incorrect rotation can

damage the fans operation.

3) The gobos, dichroic color filters and internal lenses may be cleaned with soft brush using soapy water.

4) The interior of the fixture should be cleaned using a vacuum.

5) We recommend proper lubrication of the motor wheel. The quantity of the oil must not be excessive in order to avoid

oil run outs when motor wheel rotates

Note: There is no serviceable parts inside the device except for the fuse. Maintenance and service operations

are to be carried out by authorized dealers.

Replacing the fuse: Only replace the fuse with the same type and rating.

Replacing the power cable: If the power cable of this device becomes damaged, it has to be replaced by author-

ized dealers only

Should you have further questions , please contact your dealer.

Parts List

L-HL75 HL-75W LED

1130-LD Lamp Driver

1130-DIS Display Card

P-1130 Dual Axis 7D5 Case

1130-PS Power Supply

1130-QRM Quick Release Mount Set

1130-FAN Fan

1130-ARMB Arm Body Set

1130-DISB Display Body Set

1130-HEADB Head Body Set

1130-MC Color Motor

1130-PL Primary Lens

1130MRG Rotating Gobo Motor

1130-MGR Gobo Rotator Motor

1130-MF Focus Motor

1130-FU Replacement Fuse