Instruction Manual

EN
48
the surface neness. Move the grinding
disc smoothly backwards and forwards
over the surface of the workpiece.
4. When cutting, never attempt to change
the angle of the disc to the workpiece –
this can cause it to jam and can overload
the disc so that it shatters.
5. Feed the tool in the opposite direction
to the rotation of the disc when cutting.
Otherwise there is a risk that the disc will
be forced out of the cut.
6. Abrasive discs produce the best results
when cutting very hard materials.
7. These discs can get very hot when in use.
A ring of sparks around the disc is a sign
of a hot disc. If this happens, stop cutting
and run the tool with no load at full speed
for 2 to 3 minutes to cool the disc.
8. Secure the workpiece with a clamp, clips
or vice.
MAINTENANCE
Switch o the product, wait until all moving
parts have completely stopped and remove the
battery before adjusting, maintenance and/or
replacing accessories.
The product does not contain any parts that
can be repaired by the user. Do not use water
or detergent on the product. Wipe the product
with a dry cloth. Store the product in a dry
place. Keep the ventilation openings on the
motor clean. Keep the controls free from
dust. It is normal to see sparks through the
ventilation openings.
TROUBLESHOOTING
Follow the troubleshooting instructions below
in the event of any problems.
1. If the disc vibrates or kicks, check that the
spindle screw is tightened and that the
disc is correctly tted on the spindle.
2. Replace the disc if it is damaged. Never
use damaged discs, they can shatter and
cause serious personal injury. Recycle
damaged discs in accordance with local
regulations.
3. When working with aluminium and other
soft metals and alloys the disc can quickly
become clogged and work less eectively.
4. Overloading can cause the disc to jam and
force the motor to stop. If this happens,
stop and run the tool with no load at full
speed for 30 seconds to cool the motor.
5. The product will not be overloaded if
it is used as it is intended to be used.
The overload protection automatically
switches o the product until is has
cooled if it is overloaded or the battery
temperature is higher than 75°C.
6. Switch o the product, wait 1 to 2 seconds
and then start it again if it jams or gets
blocked.