Instruction Manual

EN
35
Note the following points when
drilling in wood, metal and other
materials
• Use high speed for drills with a small
diameter and low speed for drills with a
large diameter.
• Use a low speed for hard materials and a
high speed for soft materials.
• Secure the workpiece if possible with
clamps, clips or in a vice.
• Mark the drilling point with a punch. Start
drilling at low speed.
• Pull out the rotating drill from the hole
now and then to remove dust and
shavings and to clean the hole.
Drilling in metal
Use a high speed steel drill intended for metal.
Use coolant for best results. Metal drills can
also be used for drilling in plastic. Drill rst with
a 3 mm diameter drill and then with a drill
with the required diameter.
DRILLING IN WOOD
Use a centre drill. Use a twist drill for deep
holes, and use a pin drill for holes with a large
diameter. Small screws can be driven in soft
wood without predrilling.
MAINTENANCE
WARNING!
RISK OF PERSONAL INJURY Switch o the
product and remove the battery before
cleaning and/or maintenance.
The product is maintenance-free.
• Keep the product clean, dry and free from
oil and grease.
• Make sure no liquid gets into the product.
• Use a soft, dry cloth to clean the casing.
Do not use petrol, solvent or detergent
that can damage the plastic parts.
• Check the battery charge status at regular
intervals if the product has not been used
for some time. The optimum charge is 50
to 80%. Store the product in a cool and
dry place.