Instruction Manual
EN
34
Switching on/o
Starting
Start the product by pressing the power switch
and holding it in. The work light goes on when
the power switch is fully or partly pressed. The
work light simplies working in dark areas.
FIG. 6
Switching o
Switch o the product by releasing the power
switch.
Adjusting the speed
The power switch on the product provides
variable speed control. Press the power switch
a little for low speed. The speed increases the
more the switch is pressed.
FIG. 7
NOTE:
The integrated brake function in the motor
ensures quick stop.
Mode selector
Use speed mode 1 (low speed) for small screws.
Use speed mode 2 (high speed) for large
screws.
FIG. 8
Rotation selector
Move the rotation selector to the left to screw
in screws.
Move the rotation selector to the right to
unscrew screws.
FIG. 9
Torque setting ring
Set the required torque with the torque setting
ring.
• Set a low torque for small screws and/or
soft material.
• Set a high torque for large screws and/or
hard material, and for unscrewing screws.
• Set the drilling mode by twisting the
torque setting ring to the position that
shows a drill.
• Move the mode selector forward for
drilling (mode 2).
FIG. 10
Activate power switch lock
Move the direction selector to the mid point.
This locks the power switch.
TIPS AND TRICKS
• Always check before use that the bit is
correctly tted and centred in the chuck.
• Screw bits are marked with size and
shape. If unsure, check if the bit ts the
screw head without any play.
Torque
Small screws can be damaged if they are driven
with high torque or speed.
Screw unions in hard materials
(for example metal)
The torque is very high for metal screw unions
tightened with screw sleeves. Use a low speed.
Screw unions in soft material
(for example soft wood)
Use a low speed to avoid damaging the wood
on contact with the screw head. Countersunk
screw hole