Instruction Manual

EN
32
test method, can be used to compare dierent
tools with each other and for a preliminary
assessment of exposure. The measurement
values have been determined in accordance
with EN62841-2-1:2018.
WARNING!
The actual vibration and noise level when
using tools may dier from the specied
maximum value, depending on how the
tool is used and the material. It is therefore
necessary to determine which safety
precautions are required to protect the user,
based on an estimate of exposure in actual
operating conditions (taking into account all
stages of the work cycle, e.g. the time when
the tool is switched o and when it is idling,
in addition to the start-up time).
TECHNICAL DATA
Voltage 12 V
Torque 28 Nm
Speed 0-400 / 0-1300 rpm
Chuck size 10 mm
Capacity in wood 16 mm
Capacity in steel 6 mm
Size L 16.8 x H 17.5 x D5.8 cm
Sound pressure level, L
p
A 71.1 dB(A), K= 5 dB
Sound power level, L
w
A 82.1 dB(A), K= dB
Vibration level 1.987 m/s2, K= 1.5 m/s2
DESCRIPTION
Screwdriver set included in the Meec Tools
Multiseries12 V. With accessory case that
contains 70 drills and bits, a battery (2 Ah) and
charger (0.4A).
The product is intended for drilling and screw
driving in wood, plastic and metal. The product
must only be used for its intended purpose
and in accordance with these instructions.
All other use is considered to be unsuitable.
Incorrect use, inadequate maintenance and/
or illicit use of the product can result in serious
personal injury and/or material damage.
The manufacturer cannot accept liability for
personal injury or material damage resulting
from improper use. The product is only
intended for household use.
1. Power switch with speed control
2. Rotoation selector
3. Keyless chuck
4. Torque cover
FIG. 1
ASSEMBLY
PREPARATIONS
Inserting/removing the battery
• The battery is only partially charged on
delivery. The battery must be charged
before the power tool can be used.
Lithium-ion batteries can be charged at
any time without aecting their lifespan.
Interrupting the charging will not damage
the battery.
• Charging temperature: 10 to 40°C. Check
the battery charge status at regular
intervals if the product has not been used
for some time. The optimum charge is 50
to 80%. Store the tool in a dry place.
Storage temperature: 0 to 50°C.
IMPORTANT:
Pull out the charger plug from the power
point before the battery is connected to, or
disconnected from the charger.
1. Press the battery lock (arrow 1) and push
the battery to the right (arrow 2).
FIG. 2
2. Put the battery in the battery charger.
3. Plug in the plug. The red charging
indicator light goes on.