Instruction Manual

2. Press Adaption Of The Throttle Unit. Follow the steps on the display

images. Conrm with OK or cancel with ESC.

FIG. 20

– Ignition on

– Check if any fault codes (diagnostic trouble codes) are stored.

No Diagnostic Trouble Codes must be stored.

FIG. 21

– No adaptation can be carried out if there are stored

diagnostic trouble codes.

FIG. 22

– NOTE: When all the basic conditions are met the ignition

must be switched on for at least 30 seconds before the

adaptation can start. Adaptation takes about 10 seconds.

FIG. 23

Adaptation

– Ignition o

– Ignition on

– Parameter reading

– Check that the following conditions for adaptation of the

throttle unit are met.

FIG. 24

Adaptation of the throttle unit is met.

1. Engine switched o and ignition on.

2. Battery voltage higher than 10 V.

3. Accelerator pedal fully released.

4. Vehicle stationary.

FIG. 25