Instruction Manual

EN
72
– Identify the Vehicle
– Manual Select
FIG. 4
3. The following display image is shown.
FIG. 5
4. Press System Scan. The following display images are shown.
FIG. 6
NOTE:
The option System Scan checks faulty systems and shows the number
of faults. The option Manual Select checks all supported systems.
SYSTEM SCAN
1. Select System Scan and mark ECM "Engine Control Module".
The following display image is shown.
FIG. 7
2. Select Version Information. The following display image is shown.
FIG. 8
3. Select Read Fault Codes. The following display image is shown.
FIG. 9
4. Select Erase Fault Codes and press the OK button to conrm
the question “Erase fault codes. Are you sure?” The following
information is shown on the display " Fault codes erased.
Wait 10 seconds. Switch o the ignition and switch on again.
Read fault codes to verify”.
FIG. 10
5. Select Read Datastream and press the OK button. Select View all
Items and press the OK button.
FIG. 11