User guide
How to Test Your Blood Glucose • 27
Understanding Your
Test Result
Your blood glucose test result is displayed on
the meter.
Test Result
(Example)
PM
mg/dL
Test Result
(Example)
5. Remove and discard the used test strip. The meter turns
off automatically.
6. Remove the used lancet from the lancet device. Follow
your local disposal regulations where applicable.
PM
mg/dL
Countdown
Completely Filled
Not Completely
Filled
2. Apply blood drop to the edge of the test
strip. The blood is drawn into the test strip.
Hold your finger to the edge of the test strip
until you hear a short beep or see the meter
display begin to count down.
Correct
Incorrect
Apply Blood Drop
26 • How to Test Your Blood Glucose
NOTE:
If you are not using a pump, then you may choose to
set " " to " " to save battery power.
NOTE:
Your meter arrives from the factory with " " set to
" ". If the glucose result does not flash and the pump does not
receive the glucose result, then set " " to " ". See Optional
Functions on page 37.
(Continued on next page.)
The glucose result will flash while meter is transmitting
the glucose result to the insulin pump. Removing the strip
will not automatically turn off the meter while RF
transmission is in progress (flashing). You can stop the
transmission by manually turning off the meter or
inserting a new test strip. The glucose result will stop
flashing(transmitting) when the pump receives the
glucose result or after 60 seconds.
3. The display counts down from 5 seconds as
the meter performs the test.
4. A long beep sounds and the result is
displayed and stored in the meter’s memory.
(Continued on next page.)