User guide

Using the Bolus Wizard feature 65
3 The SET START TIME 2 screen will appear.
5 The screen will return to the EDIT SETTINGS screen. You can now program your BG target(s).
BG targets
The BG target setting allows you to set glucose
targets. Because your targets may vary throughout the
day, your pump allows you to set up to eight (8) BG
targets each day. If you want to set just one target
value instead of a range, set both the low and high
values to the same number.
If your current BG is above the BG Target Range, the
Bolus Wizard feature will calculate a correction dose.
If your current BG is below the BG Target Range, the
Bolus Wizard will calculate a negative correction and
subtract it from your food bolus.
NOTE - Pumps are sent from the factory with default BG target of 100 - 100 mg/dL (5.6-5.6
mmol/L). If you adjust your BG Targets outside of 90-140 mg/dL (5.0-7.8 mmol/L) the pump
screen displays a warning that the values are acceptable but outside normal range.
4 To set just one insulin sensitivity:
To set more than one insulin sensitivity:
Press ESC.
a. Set the start time for
the next insulin
sensitivity and press
ACT.
b. Set the value for the
next insulin sensitivity
and press ACT.
c. Repeat steps a and b
to set more values.
d. Press ESC when you
are done.
(flashing)
SET START TIME 2
mg/dL
per unit insulin
_ _ _
_ : _
(flashing) set, then press ACT
SET START TIME 2*
7:30A
mg/dL
per unit insulin
_ _ _
(flashing) set, then press ACT
* Depending on how many
values you set, this number
can be 2 through 8.
INS SENSITIVITY 2*
7:30A
mg/dL
per unit insulin
50
Correct up to the lower limit
(mg/dL) 70
(mmol/L) 3.8
Correct down to upper limit
(mg/dL) 100
(mmol/L) 5.6
G
l
u
c
o
s
e
C
o
n
c
e
n
t
r
a
t
i
o
n
22.2
13.9
5.6
3.8
(mmol/L)
400
250
100
70
(mg/dL)
Target Range