User guide

Starting on insulin 47
Manual prime
Manual prime fills the infusion set tubing with insulin before you attach it to the infusion site.
Manual prime is only available after you rewind your pump.
1 After you rewind your
pump, the PREPARING
TO PRIME screen will
appear.
WARNING: Make sure the infusion set is disconnected from your body before you press ACT to
prime the pump. Never insert the reservoir into the pump while the tubing is
connected to your body. Doing so could result in an accidental infusion of insulin.
2 Press and hold ACT to start
the prime. The pump will
beep 6 times indicating the
prime has started.
3 While you hold ACT, the pump
will beep again 6 times as the
screen begins counting the prime
units being used.
4 Continue to hold ACT until insulin
droplets form on the tip of the
infusion set needle, then release.
Be sure no bubbles are in the
tubing.
WARNING: If the PRIMING - HOLD ACT screen does not display, do NOT continue. Do NOT insert the
infusion set into your body. Please contact the 24 Hour HelpLine for assistance.
Take care to remove any air bubbles during the manual prime.
PREPARING TO PRIME
Disconnect from Body
Insert/Lock Reservoir
Hold ACT to Prime
ACT
(hold)
PREPARING TO PRIME
DISCONNECT
Hold ACT
ACT
(hold)
PRIMING – HOLD ACT
ESC if
done
U
0.3
ACT
(hold)
PRIMING – HOLD ACT
U
5.1
ESC if
done