User guide

Basic programming 37
Stopping your pump
You can stop your pump with the Suspend function. Suspend stops all insulin delivery including the
current basal and any bolus or prime deliveries that are in progress. While suspended, your pump will
not deliver insulin until you Resume your pump. When basal is resumed, the pump is taken out of the
Suspend mode.
The pump will beep or vibrate about every 15 minutes on the hour to remind you that it is not
delivering insulin. Example: You suspend your pump at 11:20AM. The pump will beep/vibrate at
11:30AM, 11:45AM, 12:00PM, and so on until you resume your pump (basal resumes).
NOTE - When suspended, your pump is in Attention mode (a solid circle). When in Suspend, you can
only resume your basal or view the STATUS screen. No other functions are available.
Do these steps to suspend your pump:
NOTE - Press ESC once (three times if the Sensor
feature is ON) to view the STATUS screen and
verify that your pump is suspended.
1 Select Suspend from
the MAIN MENU, and
press ACT.
2 SUSPEND will flash. Press
ACT to stop your pump.
3 The screen will show that the pump
is suspended and the time that it
stopped. After a few minutes, the
pump will default to the HOME
screen with a solid circle.
MAIN MENU
Bolus
Suspend
Basal
ACT
(flashing)
SUSPEND
Press ACT to Stop Pump
ACT
Stopped at 1:05P
SUSPEND
STATUS U100
Suspended at 01:05P
Last Bolus N 3.8U
7:58A 22 FEB