User guide

Troubleshooting 125
8 If your pump still does not receive your BG reading from the linked meter, use the up/down buttons
to manually enter your BG (in the ENTER BG screen).
I dropped my pump
Take care to protect your pump from being dropped.
1 Check that all connections are still tightly in place.
2 Check the LCD, keypad and pump case for cracks or damage.
3 Check infusion set, including the tubing connector and tubing for cracks or damage.
4 Review the status screen, basal rates and other pump settings.
5 Perform the Selftest procedure located in the UTILITIES MENU.
6 Call the Medtronic MiniMed 24 Hour HelpLine for assistance.
I submerged my pump in water
Your pump is designed to resist accidental contact with water. Do not submerge in water during
bathing, swimming, or other water activities.
1 Pat the outside of the case until dry.
2 Open the reservoir compartment and check the compartment and reservoir for water. If wet, dry it
completely within ten (10) minutes of exposure to water. Exposure to liquids, including water or
insulin can corrode the mechanism.
3 Dry the reservoir completely—do NOT place a wet reservoir in the pump.
4 Do not use hot air to dry your pump. This may damage your pump's internal electronics.
5 Check the battery compartment and the battery—if wet, let them dry completely before using the
pump.
6 Perform a selftest.
I cannot get to the User Settings menu
If you do not hold down while pressing ACT when you have User
Settings highlighted, you will see the following screen:
1 Go to the UTILITIES screen and highlight
User Settings. Then, hold down
and press ACT.
2 See “User settings” on page 117 for information about the menu options.
This feature is not
normally accessible. To
access, consult your
User Guide.