Operating instructions

ManualsBrandsMedtronic ManualsFitness EquipmentLIFEPAK CR-T

LIFEPAK

CR–T AED TRAINER

Quick Start Reference Card

LIFEPAK

CR–T AED TRAINER

Quick Start Reference Card

Quick Start Setup Procedure

1 Turn on the Trainer using the MASTER POWER switch.

2 Press the

GREEN SELECT button on the remote control.

3 Select the desired shock protocol (the default setting is C1) using the buttons referenced in the following table.

4 Press the

GREEN SELECT button again to confirm shock protocol. The Trainer enters simulated OFF status.

5 You are now ready to begin a training session.

6 When the electrode pads are properly placed on the manikin, press the

ELECTRODE PADS button (F2) on the

remote control.

7 Use the remote control to create troubleshooting situations. Refer to the opposite side of this card for details.

Remote Control Button AED Trainer Shock Protocol Shock Order*

Fixed #1 SNNN

* S: Shock Advised (green LED)

N: No Shock Advised (red LED)

** Custom settings, C1 and C2, may be changed

(refer to operating instructions).

Fixed #2 SSNN

Fixed #3 NSNN

Fixed #4 NNNN

C1**

Custom #1 SSSSSSSSS

C2**

Custom #2 NNNNNNNNN