Operating instructions

20 LIFEPAK CR–T Trainer Operating Instructions
Setup
General Operating Settings
The procedure for changing the general operating settings (Start Prompt, Stack Shocks, Pulse Check,
Pulse Prompts, and Automatic/Semiautomatic Model) is the same for each. Table 9 identifies each
general operating setting, indicates the LED bar that corresponds to the setting, and describes the
options available.
To change the general operating settings:
1 Press the
GREEN SELECT button.
2 Press the
VOLUME button (OP, L).
3 Press the
RIGHT X ARROW button to advance to the desired operating setting (LED bar number).
4 Press the
UP S ARROW button to select the desired option (LED bar color).
5 Repeat steps 3 and 4 until you have changed all of the desired operating settings.
6 After making your changes, press the
GREEN SELECT button to save the selections. The signal sensor
flashes, indicating the selections have been saved. The Trainer enters simulated OFF status.
Figure 11 shows the LED displaying the following option settings:
• Bar 1, Automatic/Semiautomatic Model: Semiautomatic (green)
• Bar 2, Start Prompt: Voice ON (green)
• Bar 3, Stack Shocks ON (red)
• Bars 4 and 5, Pulse Check OFF (green, green)
Figure 11 General Operating Setting Options
Table 9 General Operating Setting Options
Operating Setting Bar Number Options
Automatic/Semiautomatic
Model
1 Green = Semiautomatic; Red = Automatic
Start Prompt 2 Green = Voice ON; Red = Voice OFF
Stack Shocks 3 Green = OFF; Red = ON
Pulse Check 4, 5 Green, Green = NEVER
Red, Red = ALWAYS
Yellow, Yellow = AFTER 2ND NSA
Green, Yellow = AFTER EVERY NSA
Pulse Prompts 6 Green =
CHECK FOR PULSE
Red = CHECK FOR BREATHING
Yellow = CHECK FOR SIGNS OF CIRCULATION
Bar Number
1234567890