Operating instructions

LIFEPAK CR–T Trainer Operating Instructions 19

Setup

Configuring Shock Protocols

You can change the Custom #1 and Custom #2 shock protocols to any configuration of

SHOCK and

NO SHOCK ADVISED prompts, up to nine selections.

To change Custom #1 and Custom #2 shock protocols:

1 Press the

GREEN SELECT button.

2 Press either the

MOTION button (C1) for Custom #1 or the PAUSE button (C2) for Custom #2.

3 Press the

UP S ARROW button to select shock or no shock. The first bar can be set only to shock or

no shock.

4 Press the

RIGHT X ARROW button to advance to the next bar and press the UP S ARROW button to

select shock or no shock.

5 Repeat Step 4 until you have set the scenario you want to demonstrate and then press the

UP S

ARROW button until remaining LED bars turn blank.

6 Press the

GREEN SELECT button to save the change. The signal sensor flashes, indicating the change

has been saved. The Trainer enters simulated OFF status.

Figure 10 shows the LED displaying the following shock protocol: Bar 1, no shock (red); Bar 2, shock

(green); Bar 3, no shock (red); Bar 4, shock (green); Bar 5, end scenario (blank).

Figure 10 Custom #1 and #2 Options

Table 8 Shock Protocol Options

Button Shock Protocol Order LED Display*

F1 Fixed #1 SNNN

F2 Fixed #2 SSNN

F3 Fixed #3 NSNN

F4 Fixed #4 NNNN

C1 Custom #1 SSSSSSSSS

C2 Custom #2 NNNNNNNNN

* = Shock (Green) = No Shock (Red) = End Scenario (Blank)

12345678

9 0

12345678

9 0

12345678

9 0

12345678

9 0

Bar Number

1234567890