Operating instructions

12 LIFEPAK CR–T Trainer Operating Instructions
Using the LIFEPAK CR–T AED Trainer
Using the Remote Control Cable
To use the remote control cable, insert the cable’s right-angle connector into the remote control
receptacle. Insert the connector on the opposite end of the cable into the receptacle located on the side
of the Trainer (see Figure 2, page 4).
Disconnect the remote control cable by grasping the connector on the side of the Trainer and gently pulling
away from the Trainer. Disconnect the right-angle connector from the remote control in the same way.
PREPARING FOR A TRAINING SESSION
1 Connect the electrode packet to the Trainer as follows:
– Press the
LID RELEASE/ON-OFF button to open the Trainer lid.
– Insert the electrode pads connector into the Trainer cable receptacle until it snaps into place
(see Figure 7).
– Insert the black plastic anchor pin on the electrode packet into the anchor receptacle at the upper
left corner of the Trainer (see Figure 7).
– Ensure that the lower edge of the packet is under the fin on the lower front part of the Trainer.
– After the electrode packet is in place, close the Trainer lid.
OP L
Adjust volume of voice
prompts
Each time the Trainer is turned on, the volume level defaults to
the level used during the previous session.
Three volume levels are available (low, medium, high). Press the
VOLUME CONTROL button to select the volume level desired. As
you press the button, the volume increases. View the LED
display to observe volume changes. When the highest volume is
reached, the next press returns the volume to low.
GREEN SELECT button
The
GREEN SELECT button is used to change the shock protocol
and general operating setting options.
When the
GREEN SELECT button is pressed, the LED display
flashes green to indicate setup mode is activated.
Press the
GREEN SELECT button twice to display the shock
protocol.
For more information, refer to Section 3, beginning on page 15.
RED SELECT button
The
RED SELECT button is used to change CPR Time 1,
CPR Time 2, and the Language Option.
When the
RED SELECT button is pressed, the LED display flashes
red to indicate setup mode is activated.
For more information, refer to Section 3, beginning on page 15.
UP ARROW button
The
UP ARROW button is used to select a setting option.
RIGHT ARROW button
The
RIGHT ARROW button is used to advance through the
settings.
Table 6 Remote Control Button Functions (Continued)
Button Function Operation and Description