Operating instructions

LIFEPAK CR–T Trainer Operating Instructions 7

Getting Started

Remote Control and Remote Control Cable

The remote control is stored in the remote control compartment (refer to page 4). The dual-function

keys are used to configure the Trainer operating settings prior to a training session and to alter

simulation during training scenarios. The remote control communicates with the Trainer through signals

to the infrared sensor located in the back of the Trainer.

The remote control cable, stored in the storage compartment (refer to pages 3 and 4), can be used as

an alternative to the infrared sensor. Refer to Section 2, beginning on page 9, for information about

connecting the remote control cable.

Figure 5 shows the remote control and remote control cable with the features identified in Table 5.

Remote control button functions are described in Section 2, beginning on page 10.

Figure 5 Remote Control and Remote Control Cable

Table 5 Remote Control Features (Setup Functions)

1 Feature not available (F1) 8 Pause button (C2)

2 Electrode pads button (F2) 9 Volume control button (OP) (L)

3 No advised shock button (T1) 10 Green select button

4 CHARGE-PAK button (F3) 11 Red select button

5 Service button (F4) 12 Up arrow button

6 Attention button (T2) 13 Right arrow button

7 Motion button (C1) 14 Remote control cable