Operating instructions

4 LIFEPAK CR–T Trainer Operating Instructions
Getting Started
Figure 2 LIFEPAK CR–T AED Trainer Outside Controls, Indicators, and Labels (Back and Side)
4 CHARGE-PAK Trainer The CHARGE-PAK Trainer is not functional. It is used only to
demonstrate how to remove and replace the CHARGE-PAK.
5 Lid release/On-Off
button
Button that opens the Trainer lid and simulates turning on the
defibrillator. Pressing this button for approximately 2 seconds after the
lid is open simulates turning off the defibrillator.
6 Storage compartment Storage compartment for the remote control cable and shock button
cover.
7 Battery compartment Compartment that holds four D-cell alkaline batteries.
Table 2 Outside Controls, Indicators, and Labels (Back and Side)
8 Remote control signal
sensor
Sensor used for wireless remote control operation. The signal from the
remote control must be detected at this sensor for proper
communication.
9 Light emitting diode
(LED) display
Display containing ten LED bars that are viewed to confirm selections
when operating settings are changed. The LED display is also used to
verify volume level when the volume is adjusted.
10 Remote control
compartment
Storage compartment for the remote control.
11 Software download
receptacle
Connection point for loading software to the Trainer.
12 Remote control
receptacle
Connection point for the remote control cable.
13 Master power
switch Press and release switch that provides power to the Trainer.
14 CHARGE-PAK Trainer
compartment
Compartment that accommodates the removable CHARGE-PAK
Trainer.
Table 1 Outside Controls, Indicators, and Labels (Top and Bottom) (Continued)
Back Side
10
8
11
12
13
14
9