Operating instructions

LIFEPAK CR–T Trainer Operating Instructions 3

Getting Started

CONTROLS, INDICATORS, AND LABELS

There are several important controls, indicators, and labels on the LIFEPAK CR–T AED Trainer with

which you should become familiar.

Outside Controls, Indicators, and Labels

The outside controls, indicators, and labels are identified in Figure 1 and Figure 2 and described in

Table 1 and Tabl e 2.

Figure 1 LIFEPAK CR–T AED Trainer Outside Controls, Indicators, and Labels (Top and Bottom)

Table 1 Outside Controls, Indicators, and Labels (Top and Bottom)

1 Carrying handle The carrying handle is used to transport the Trainer.

2 Readiness display This display simulates whether the defibrillator is ready for use or needs

attention. The remote control and CHARGE-PAK activate the following

indicators:

OK indicator. Simulates that the defibrillator is ready for use.

CHARGE-PAK indicator. Simulates that the CHARGE-PAK

needs to be replaced or is not installed.

Attention indicator. Simulates that the internal battery of the

defibrillator is low.

Wrench indicator. Simulates that there is a condition that

prevents or could prevent normal operation of the defibrillator.

Service is required.

3 Lid The top of the Trainer. After the lid is open, the Trainer begins training

scenarios. When the lid is closed, the Trainer simulates the defibrillator

in OFF status.

Top Bo tt om