User's Manual

6 English SEEQ MCT Instructions for use
M958549A001 Rev B
Refer to doc # A73903 for Printing
Instructions.
M958549A_ch.fm 3/12/15 2:34 pm
4" x 8" (101 mm x 203 mm)
Medtronic Confidential
mdvtldct_R1.5
Step 3: Prepare for Wearable Sensor application
IMPORTANT: Monitoring will be affected if hair is not trimmed or
if skin is not cleaned with the Prep Wipe. If this happens, you
may be required to use another Wearable Sensor.
IMPORTANT: Take care not to touch the adhesive gel while you
handle the Wearable Sensor.
• Trim as much hair as
possible from the intended
location (for men) on the upper
left chest, as seen in the
diagram (for example, using an
electric razor or hair trimmer).
Trim an area slightly larger than
the Wearable Sensor.
• Using the Prep Wipe
provided, clean the skin where
the Wearable Sensor will be
applied and allow time to dry
(clean an area slightly larger
than the Wearable Sensor).
• Do not use any creams or
lotions on your skin before
application as this will impact
monitoring.
• Remove the Wearable Sensor
from the foil pouch by tearing
at the notch. If you see any
illuminated lights on the
Wearable Sensor before
application, contact Medtronic
Customer Support at 1-877-
247-7449.
• Grasp the top side of the
Wearable Sensor as seen in
the diagram and turn it over to
view the underside.
• Carefully remove each tab
from the underside of the
Wearable Sensor to expose
the adhesive gel.