Users Manual

To insert the reservoir into your pump:
1. If you are using the pump for the first time, remove the shipping cap from
the reservoir compartment.
2. Rewind your pump if you have not yet done so. See Rewinding your pump, on
page 118 for more information.
3. Insert the reservoir into the top of the reservoir compartment.
4. Turn the tubing connector clockwise until the connector is locked into the
pump. The tubing connector should be aligned horizontally with the pump
case as shown in the following example.
tubing connector
5. Your pump should be displaying the New Reservoir screen shown in the
following example. Select Next to continue.
6. Select and hold Load until you see a checkmark on the screen and your
pump beeps or vibrates. Holding Load moves the piston up in the reservoir
compartment until it engages with the bottom of the reservoir.
124 Chapter 5