How-To Guide
Table Of Contents
- M998590A011DOC_A_FINAL_UserGuide_Part1_5
- Setting up CGM
- Using CGM
- SmartGuard Auto Mode
- About SmartGuard Auto Mode
- Before using SmartGuard Auto Mode
- Setting up SmartGuard Auto Mode
- SmartGuard Auto Mode Readiness
- Home screen with SmartGuard Auto Mode
- Using SmartGuard Auto Mode
- Safe Basal
- Block Mode when in SmartGuard Auto Mode
- Setting Temp Target
- SmartGuard Auto Mode sensor graph
- Enter BG
- SmartGuard Auto Mode Bolus
- Alert Silence
- Exiting SmartGuard Auto Mode
- Returning to SmartGuard Auto Mode
- M998590A011DOC_A_FINAL_UserGuide_Part2
Title and text Type Explanation Next steps
Cal required for
Auto Mode
Enter a BG and
calibrate sensor
for Auto Mode.
Alert Calibration may
be required by
Auto Mode, even
when SG values
are available.
• Select OK to clear the alert.
• Check your BG and enter it into
your pump.
• Calibrate your sensor using the
BG that you entered.
High BG XXX
mg/dL
Check infusion
set. Check
ketones. Monitor
BG. Confirm BG?
Alert Your BG meter
reading is above
250 mg/dL.
This alert applies
only to Auto
Mode. There is
an equivalent
alert for Manual
Mode. See Pump
alarms, alerts, and
messages, on
page 244.
Select No to prevent the remote
BG from being used by your pump.
Select Yes to confirm the BG
reading.
CareLink software alert and message
The following table lists the most common or serious alerts and messages related
to CareLink software. The table also explains the meaning, consequences, and the
reasons why these notifications appear, and provides steps for problem resolution.
If you get an alarm, alert, or message that is not listed, select OK to clear the
notification and call 24-Hour Technical Support.
278 Chapter 13