How-To Guide

2. Select Cancel Alert Silence.
Exiting SmartGuard Auto Mode
The pump will exit SmartGuard Auto Mode:
Auto Mode has been in Safe Basal for 90 minutes. See Safe Basal, on page 226.
A High SG alert has occurred.
You have not cleared any suspend event messages within four hours.
You manually turned off the Sensor feature or disconnected the transmitter.
Some alarms cause the pump to exit SmartGuard Auto Mode and also turn the
Auto Mode feature off. Auto Mode is turned off if an alarm initiates a pump reset.
If this occurs, you will no longer see the SmartGuard Auto Mode shield on your
Home screen. You must turn the Auto Mode feature on again and go through a
five-hour warm-up period.
You can turn off Auto Mode at any time. For more information, see Setting up
SmartGuard Auto Mode, on page 221.
Returning to SmartGuard Auto Mode
If you have automatically transitioned to Manual Mode, you can return to Auto
Mode if all readiness conditions are satisfied and you enter a BG. For more
information, see SmartGuard Auto Mode Readiness, on page 223.
Note: If you have turned Auto Mode off, you cannot return to Auto
Mode until you turn Auto Mode on again.
You can return to Auto Mode if the following conditions are satisfied:
•Auto Mode is enabled on your pump.
SmartGuard Auto Mode
SmartGuard Auto Mode 237