User Manual

54 Chapter 3
2. Scroll through the history by using the Up arrow button to go from oldest to newest glucose value in 5-minute
increments. Press the Down arrow button to go from newest to oldest glucose value in 5-minute increments. In
the example below, the glucose value was 112 mg/dl (6.22 mmol/l), 5 hours and 25 minutes ago.
3. If the ACT button is pressed, the scrolling display will switch from 5- to 30-minute increments, and an
asterisk ( ) will be displayed next to the time increment. If you now press the Up arrow button, the
history will go from oldest to newest glucose value in 30-minute increments. If you press the Down arrow
button, the history will go from newest to oldest glucose value in 30-minute increments. In the example
below, the glucose value was 96 mg/dl (5.33 mmol/l) 4 hours and 35 minutes ago. Press the ACT button to
go back to scrolling in 5-minute increments. The asterisk will no longer be displayed.
4. If the glucose value is lower or higher than operational range of 40-400 mg/dl (2.2 -22.2 mmol/l),
the screen will display LO or HI where the glucose value is normally found. See example below.
NOTE - When there is no calibration for the Sensor value, NO CAL* will be displayed on the bottom
of the screen in place of NOW. In these cases, “---” will be displayed for the glucose value.
When the Sensor value is unstable, NOISE* will be displayed on the screen. And when the Sensor
value is unavailable due to bad or no telemetry, MISSED* will be displayed on the screen.
-5h 25M
GLUCOSE
HIST:
11:57
PM
112
mg/dl
X
-4H 35M X
GLUCOSE
HIST:
11:57
PM
96
mg/dl
-5H 25M
GLUCOSE
HIST:
mg/dl
LO
11:57
PM