User Manual

38 Chapter 2
5. Press the ACT button again to go to the second digit.
6. The second digit will now be blinking. Use the Up or Down arrow button to choose the second digit in
your Transmitter ID number.
7. Press the ACT button once again to go to the third digit.
8. Keep using the Up or Down arrow to choose numbers for each of the digits left. Then press the ACT
button to go to the next digit. The example below uses 7596.
NOTE - If the ID number is less than 7 digits, make sure leading zeros are entered.
9. Press the ACT button after the 7th digit has been entered to save the ID in the Monitor. Press SEL
2 times to go to the EXIT screen, followed by ACT to go back to the HOME screen.
SET
0007596