User Manual

102 Chapter 6
Cleaning the Monitor
1. Use only a damp cloth and mild detergent mixed with water to clean the outside of your Monitor.
2. Wipe excess soap from the Monitor with a clean, damp cloth.
3. Dry with a separate clean cloth.
4. Never use organic solvents, such as lighter fluid, nail polish remover, or paint thinner to clean your
Monitor.
5. Keep the reservoir and battery compartments dry and away from moisture.
6. Do not use any lubricants with your Monitor.
7. Disinfect the Monitor by wiping the outside with an isopropyl alcohol wipe.
Cleaning the Transmitter
For single-patient use
1. Wash your hands thoroughly.
2. Dampen a clean cloth with mild liquid soap and warm water, and wipe the outside of the
Transmitter, cable and connector. Do not wet the inside of the connector.
CAUTION: Do not place the Transmitter into the liquid soap solution.
3. Hold by the Transmitter end and rinse the Transmitter under warm tap water. Be careful not to get
the inside of the connector wet.
4. Using an antibacterial hand sanitizer (readily available at your local drugstore) on a clean, dry cloth,
wipe down the Transmitter, cable and connector. Make sure the inside of the connector does not get
wet.
5. Place the Transmitter on a clean dry cloth and allow to air dry for 2-3 minutes.